Edge-type hydraulic filters

This is also referred to as a full flow filter, which means that all the oil in the system passes through it. Figure 7.7 illustrates an edge-type filter.


The edge-type filter consists of a stack of disks with holes in their center, like flat doughnuts, with very little separation between them. When entering the filter, fluid is guided from the bottom at the outer side of the stack. Before leaving the filter, it comes out of the center of the stack having passed through the disks. Impurities in the oil are left behind on the outer edge of the stack. A scraper blade moves over the outer surface of the stack, wiping off all the dirt collected. The blade is operated manually by means of a handle at the top of the filter housing.

Leave a Reply

Your email address will not be published. Required fields are marked *